First a picture of a tablecloth was acquired. This was made into a postcard and set as the floor. Next a can preset was made. The label was changed to the label of the soda made before. The label was cropped and adjusted for minimal distortion. Next a torus was made. The torus was colored and the material was adjusted. It was made slightly shiny and reflective while still bumpy. Next the ring was added. The material was changed so that it was gold and it reflected a lot and was shiny. The can also was made shiny, although this can only be seen on the bottom of the can. A 360 degree photo of a park was used for an environment. This gave a certain tone to the picture as if it was taken outside.
First a picture of the Elucidator was acquired. First the blade was masked out. The blade was then extruded. The extrude depth was set to 0 and the bevel and inflate functions were used to create the shape of the blade. Next the plate that sits on the base of the blade was masked out. The extrusion depth was set to the maximum width of the blade caused by the bevel. The bevel and inflation tool was used to round out the edges of the plate. Next the handle was masked out. It was extruded with a depth of 0 and the bevel and inflate tool, mainly the inflate tool, was used to make it round. The pummel was then masked out and the same procedure used for the blade was used for the pummel. This entire process was repeated for the second sword. Next, a picture of grass was used. It was made into a postcard and set as the ground. It was duplicated several times so that it covered the entire screen. A picture of the sky was placed on the bottom and is used as the background. The material on the blades was adjusted so that the blades are slightly reflective.